Prodigy Dartboard Replacement Instructions

Thank you for reaching out. You will need the USB included with your Prodigy Replacement Board in order for the new board to work properly with your Prodigy Dartboard.  

I have attached a copy of the instructions as well as included the steps below.

This video may be helpful: Prodigy Dartboard Replacement

D9001W Prodigy Board Replacement

1. With Prodigy face up on a work surface, remove retaining nut from back of prodigy. Set nut, washer and spring aside for later use.
2. Remove old board by lifting it straight up and out of Prodigy.
3. Write down the serial number on back of your replacement board.
4. Install the shaft into threaded insert in back of replacement board and tighten.
5. Insert replacement board into Prodigy. Make sure dot on the face of replacement board is at the top.
6. Secure replacement board with spring, washer and nut removed earlier.
7. Locate USB drive sent with replacement board. With prodigy powered on, insert the USB drive in the USB slot located on the back of the unit close to the power cord.
8. LED lights will blink once to show the new board configuration is done. You can check the boards tab of the app or TV output to see that the board serial number matches the number written down earlier.

Please let us know if you have any questions.